|
# Example psplink configuration file.
# usbmass=[0 1] Enable USB mass storage. Set to 1 to enable automatically
usbmass=1
# usbhost=[0 1] Enable USB host file system. Set to 1 to enable automatically
usbhost=1
# pid=num Set the product ID for hostfs allows you to use multiple PSPs at one time
# Must specify the PID using the -p option of usbhostfs_pc
# pid=0x1C9
# pluser=[0 1] Enable the PSPLink user module
pluser=1
# resetonexit=[0 1] Specify wheher to reset psplink when sceKernelExitGame
# is called
resetonexit=1
# sioshell=[0 1] Specify whether to start up the sio shell
sioshell=0
# kprintf=[0 1] Specify that SIO should be used for kprintf only, setting sioshell
# to 1 overrides this setting.
kprintf=1
# wifi=[0..N] Specify wifi should be enabled, the number is the
# configuration to use if > 0
wifi=0
# wifishell=[0 1] Specify whether to start up the wifi shell
wifishell=0
# usbshell=[0 1] Specify whether to start up the usb shell
usbshell=1
# usbgdb=[0 1] Specify whether to use USB gdb or wifi gdb
usbgdb=1
# startsh=path Specify a script to run at startup
# startsh=ms0:/scripts/start.sh
# conshell=[0 1] Specify whether to start up the console shell
conshell=0
# consinterfere[0 1] Specifiy whether the consoleshell may interfere with
# programs in execution
consinterfere=0
# the commands that is run when buttons are pressed in the console shell
conscrosscmd=ld ms0:/sprite.elf
conssquarecmd=thlist
constrianglecmd=modlist
conscirclecmd=
consselectcmd=meminfo
consstartcmd=ls
consdowncmd=scrshot ms0:/scshot.bmp
consleftcmd=usbmoff
consrightcmd=usbmon
consupcmd=cop0
# prompt=... Set the psplink shell prompt
# There are some escape characters, mainly %d to print the current dir
prompt="%d> "
# path=... Set the psplink shell path
# Each path is separated by a semi-colon, you can specify up to around 128 characters
# path=ms0:/apps;ms0:/
# pcterm=[0 1] Indicates whether we are using pcterm as a client or normal
# tools
pcterm=0
# baud=[4800..115200] Set the SIO baud rate (should only use as a last resort)
# baud=115200
# modload=path Load a module on start up, repeat as necessary for more modules
# Example: load the modules for networking
# modload=flash0:/kd/ifhandle.prx
# modload=flash0:/kd/pspnet.prx
# modload=flash0:/kd/pspnet_inet.prx
# modload=flash0:/kd/pspnet_apctl.prx
# modload=flash0:/kd/pspnet_resolver.prx
| 
